11 September 2026
How to Fit a Euro Cylinder Lock Yourself: Step-by-Step Guide
How to change a euro cylinder lock on a uPVC, composite or timber door in minutes with a screwdriver, and when to call a locksmith.

Updated November 2026. Written by the WD Locks team, the lock shop of Watchdog Locksmiths, 397-399 Greenford Road, Greenford UB6 8RF. Our Watchdog 3 Star ALPS locks are BSI Kitemark 3 Star TS 007 tested, and installation is available from DBS-checked Watchdog locksmiths.
Key takeaways
- Changing a euro cylinder usually takes about 10 minutes and needs only a screwdriver.
- Measure first so the new cylinder sits flush and does not stick out.
- Keep the door open while you test the new lock so you cannot lock yourself out.
- If the door will not lock after fitting, or the lock is not a standard euro cylinder, call a locksmith.
Replacing a euro cylinder is one of the simplest security upgrades you can do at home. If you can use a screwdriver and a ruler, you can swap an old cylinder for an anti-snap one. Follow these steps, and if anything does not go to plan, our locksmiths are a call away.
Before you start
- Order the right size. Follow our guide to measuring a euro cylinder.
- Gather tools: a screwdriver and your old key.
- Leave the door open throughout and keep someone with a spare key nearby.
Step by step
- Remove the fixing screw from the edge of the door, level with the lock.
- Turn the old key about 45 degrees so the cam lines up, then pull the old cylinder out.
- Check the new cylinder against the old one: same sizes, same position of the cam.
- Slide the new cylinder in with the key turned the same way, until the screw hole lines up.
- Refit the fixing screw and tighten it firmly but do not over-tighten.
- Check it sits flush with the handle plate and does not stick out by more than a few millimetres.
- Test it with the door open. Lock and unlock several times with each key.
- Test it with the door closed, while someone holds the other key outside.
If something does not work
| Problem | Likely cause | What to try |
|---|---|---|
| Key will not turn | Cylinder not centred or cam not engaged | Loosen the screw, adjust the position and retighten |
| Bolts do not move | Cam turned to the wrong position | Refit with the key at the same angle as before |
| Cylinder sticks out | Wrong size ordered | Order the correct size. See the measuring guide |
| Door will not lock | Misaligned door or keep | This may be a hinge or alignment issue; ask a locksmith |
Register your lock
After fitting, register your Watchdog lock so your guarantee is active. See the guarantee registration page and the guarantee terms.
When to ask a locksmith to do it
If you are unsure of the size, if the door is under strain, or if you would rather have it done properly, our DBS-checked locksmiths can measure and fit it. See Watchdog Locksmiths lock replacement.
Frequently asked questions
How long does it take to change a euro cylinder?
Do I need special tools?
Can I fit it on a uPVC door?
What if my door has a thumb turn?
Ready to fit your new cylinder?
See the Watchdog 3 Star ALPS cylinder or contact us and we will help you choose the right lock and size.
Sources and further reading
Written by the Watchdog Locksmiths team. Questions about your door? Talk to an expert.

